Improve Photos in a Moment
Download App
Once physically installed, you must digitally configure the sensor via your control unit: B&G RF300 Rudder Feedback Unit | Autopilot - Simrad
The unit uses a variable frequency output to communicate the angle directly to the autopilot computer. Alignment and Testing
The . It provides critical positioning data via a unique variable frequency output signal directly to your autopilot computer to ensure smooth, accurate auto-steering.
The Y₁ dimension (distance from rudder post center to tiller ball joint) must be equal to the Y₂ dimension (distance from lever pivot to transmitter rod ball joint). Step-by-Step Installation Instructions 1. Mounting the RF300 Sensor simrad rf300 installation manual
center to its ball joint (Y2). This ensures a 1:1 mechanical relationship. Wiring & Connections : The
Before installing the RF300, prepare the following tools and components: Simrad RF300 unit with transmitter rod and ball joint. Electric drill and tap set (5 mm). Mounting platform or blocking material (if necessary). Screws and mounting hardware. 3. Mounting the Simrad RF300
Attach the transmitter rod to the ball joint only after both the rudder and the RF300 are centered. Pre-adjusted Arm Once physically installed, you must digitally configure the
If you need the Simrad RF300 unit for your installation, here are some options. Simrad Rudder Reference Series. RF300 Newport Marine Supply Free by 6/12 Simrad Rf300 Rudder Feedback by Hodges Marine Hodges Marine Free by 6/5 Simrad RF 300 Rudder Feedback Unit - 20193744 Defender Marine Free by 6/12
transmitter lever to its center position using the (the lever should be opposite the cable entry).
The unit is mechanically linked to the rudder tiller arm or quadrant. Ensure all moving parts are secured properly to avoid failure at sea. The Y₁ dimension (distance from rudder post center
Rotate the RF300 transmitter lever to its center position using the alignment mark (opposite the cable entry).
: It outputs a variable frequency signal centered at 3400 Hz , with a change of 20 Hz per degree of rudder movement.
Ensure the distance between the rudder stock center and the RF300 shaft center matches the length of the linkage rod. 2. Establish Electrical Midships Alignment
Proper power and wiring connections are essential for safe and reliable operation of the RF300 system.
Q: How do I update the software on my RF300 system? A: Check the Simrad support website for software updates and follow the instructions provided to install the latest version.