The G41 chipset is very picky about high-density DDR3 modules.
Intel G41 Express (Northbridge) and Intel ICH7 (Southbridge). Socket: LGA 775 (Socket T).
H-IG41-uATX (Rev 1.1) , often known by its codename " ," is a classic Foxconn-manufactured motherboard used extensively in HP and Compaq desktop systems like the HP Compaq 500B Core Specifications Processor Support : Utilizes the
Keep it there for , then put the jumper back onto Pins 2 and 3 . h-ig41-uatx rev 1.1 manual
If you hear 3 long beeps, the motherboard cannot detect your memory. Remove the sticks, clean the gold contacts with rubbing alcohol, and re-insert them firmly until the side clips snap shut.
The front panel header is where you connect your case's power button, reset switch, and status LEDs. This header is located on the bottom-right corner of the motherboard.
The H-IG41-uATX (Revision 1.1) is a legacy motherboard commonly found in HP and Compaq Pavillion desktop systems, such as the Slimline series. Manufactured by Foxconn (often referred to by its codename, Eton), this board utilizes the Intel G41 Express chipset. Since official digital manuals for these OEM boards are often difficult to locate, this guide serves as a comprehensive technical reference for installation, jumper settings, and hardware compatibility. Technical Specifications The G41 chipset is very picky about high-density
: Supports Intel Core 2 Quad, Core 2 Duo, Pentium Dual-Core, and Celeron processors with a Front Side Bus (FSB) of up to 1333 MHz. Memory : Two 240-pin DDR3 DIMM slots.
Two slots for DDR3 SDRAM , supporting speeds of 800/1066/1333 MHz.
It is unlikely that 130W Core 2 Extreme processors are supported due to the budget VRM design. 3. Memory (RAM) Configuration H-IG41-uATX (Rev 1
Connect to Pin 2 (Positive/Anode) and Pin 4 (Negative/Cathode)
If the motherboard turns on (fans spin) but displays no video signal, follow these sequential steps: