Before diving into operation, it is essential to understand the structural and mechanical limitations of the machine. The Amada Pega 357 generally features the following core specifications: 30 Tons (270 kN) Maximum Sheet Thickness: 0.250 inches (6.35 mm)
The user manual details the specific programming language required to run the machine safely. Standard G-codes include: Absolute / Incremental programming. G92: Setting the coordinate system reference point. G00: Rapid positioning of X and Y axes. X, Y: Coordinate positions for the punch.
Incremental programming (positions are referenced from the current tool position).
The is a legendary workhorse in the sheet metal fabrication industry . As a 30-ton mechanical turret punch press, it is renowned for its reliability, speed, and heavy-duty performance. However, maximizing the lifespan and efficiency of this vintage machine requires strict adherence to its technical documentation.
Program stop (allows the operator to clear slugs, check parts, or adjust clamps). M02 / M30: End of program. M80 / M81: Auto-repositioning cycle active / inactive. amada pega 357 user manual
The safety section is the most critical part of the Amada Pega 357 manual. Turret punch presses exert immense mechanical force and move at lethal speeds. Daily Pre-Start Checklist
Inspect the clutch and brake gap measurements against factory tolerances (typically measured with a feeler gauge).
Switch the machine to manual jog mode, hold down the "Overtravel Release" button, and slowly jog the axis back into the safe working envelope. Clutch/Brake Malfunction
This comprehensive guide serves as an operational overview of the , compiling critical information regarding system specifications, control panel operations, daily maintenance, and troubleshooting protocols. 1. Machine Specifications & Technical Overview Before diving into operation, it is essential to
Used for entering, modifying, or deleting G-code programs directly on the console.
A full diagram shows stations 1 through 58. The manual explains:
Clean dust from the proximity sensors on the locking pin cylinders. Verify that the pneumatic pressure is adequate to retract the pins. "X/Y Axis Over-Travel" (Alarms 500-505)
Allows the operator to enter single lines of G-code command manually. This is highly useful for quick, one-off holes or tool positioning without loading a full program. Jog / Manual Mode G92: Setting the coordinate system reference point
Incremental programming (coordinates are referenced from the current tool position).
When the machine stops or throws an alarm, the manual provides structured diagnostics. Problem 1: Material Stripping Failures
If an axis hits a physical limit switch, this button bypasses the interlock so operators can manually jog the machine back into the safe working envelope. 3. Tooling and Turret Alignment Setup