Rok Power Washer Instructions [exclusive] Guide

Operating your power washer effectively requires understanding distance, angles, and nozzle selections. Selecting the Right Nozzle

Safety should always be your top priority when using a power washer. Here are some essential safety precautions to keep in mind:

: Connect the high-pressure hose to the trigger gun and attach the appropriate wand or nozzle.

Turn the faucet on fully to ensure adequate water pressure. rok power washer instructions

Remove the chemical siphon tube or empty the soap tank. Run clean water through the low-pressure nozzle for one minute to flush detergent residues out of the pump.

Switch back to high pressure and rinse thoroughly from top to bottom. 7. Shutdown Procedure Proper shutdown prevents damage to the unit: Switch OFF: Turn the ROK motor switch to "OFF" (0). Turn Water OFF: Close the water supply faucet.

ROK Power Washer: Quick Setup and Operating Guide Operating a ROK power washer effectively involves proper assembly, priming, and safety checks to ensure the pump remains undamaged and the machine delivers consistent pressure. Whether you are using a compact 1400W model or a heavy-duty 2000W unit, the core operational steps remain largely consistent across the electric range. 1. Pre-Operation Assembly Turn the faucet on fully to ensure adequate water pressure

: If using an electric model, plug it into a grounded outlet. Ensure any GFI protection on the plug is reset. Fuel and Oil (Gas Models)

Before starting your ROK power washer, follow these steps to assemble it correctly:

Ensure the power switch on the machine is in the position. Switch back to high pressure and rinse thoroughly

Ensure your garden hose delivers at least 5 gallons per minute (GPM) at a steady pressure. Low water flow starves the pump, causing permanent internal damage.

Starting an electric power washer requires purging air from the system to protect the pump from cavitation: Turn on Water Supply

Screw the quick-connect water inlet adapter into the water inlet on the machine. Make sure the filter is inside to prevent debris from entering the pump. 3. Setup and Water Connection