Vag Eeprom Programmer 119g Work New! -

is a specialized, lightweight software application designed to read, write, and modify the non-volatile Electrically Erasable Programmable Read-Only Memory ( EEPROM ) of Volkswagen Audi Group (VAG) vehicles via a standard OBD2 port. For DIY automotive enthusiasts and locksmiths, it is one of the most efficient tools for extracting Secret Key Codes (SKC), programming immobilizers, resetting airbag crash data, and managing instrument cluster adaptations on older K-Line vehicles. Core Capabilities of VAG EEPROM Programmer 1.19g

It is typically used with a "dumb" KKL diagnostic cable (often FT232 chipset) to communicate directly with VDO instrument clusters, immobilizers, and ECUs. Key Functions

: Version 1.19g is notable because it can communicate through a Virtual COM Port (VCP) Operating Systems vag eeprom programmer 119g work

: Standard OBD scanners often cannot clear "crash data" codes stored after a minor collision. This tool reads the SRS Airbag EEPROM to wipe hard fault codes and reset the module.

According to forum posts (Digital-kaos, MHH Auto, DK): Key Functions : Version 1

Right-click your cable (e.g., USB-SERIAL CH340 or FTDI) and select . Under the Advanced tab, ensure Load VCP is checked.

This is crucial for older VAG vehicles (roughly 1995–2005) where security data ( Immobilizer/PIN codes) and mileage information are stored in specific memory chips rather than being easily accessible via the standard OBD protocol. Under the Advanced tab, ensure Load VCP is checked

: Version 1.19g is the most common stable release, though some vendors now bundle a 1.20 version with expanded chip support.

: Double-check that your latency is locked to 1ms. If you have an aftermarket radio installed, it may be shorting out the K-Line diagnostic wire behind the dashboard. Unplug the radio harness completely and re-test the connection. "Rx/Tx Timeout"