Body Sculpture Bc 5700 Magnetic Bike Manual Jun 2026

The LCD tracks real-time data such as time, speed, distance, theoretical calories burned, and body fat percentage. Silent Operation:

Displays the grand total distance accumulated by the bike across all sessions since the last battery replacement.

) that automatically adjust the magnetic tension to simulate varied terrain.

Feed the wires through the top and plug them into the rear of the LCD console.

Fix the padded saddle onto the horizontal seat slider. Tighten the nuts beneath the seat until the saddle does not tilt. Body Sculpture Bc 5700 Magnetic Bike Manual

Place the magnetic bike on a solid, flat, and level floor surface. Use a protective mat underneath to safeguard your carpet or hardwood flooring.

If you are still in the box phase, the manual usually outlines a straightforward process, but here are the "insider" tips that the standard diagrams often miss:

Assemble the bike on a clean, flat surface. Lay down a mat to protect your flooring. Step 1: Stabilizer Installation

Buried in a note about "magnetic brake alignment" was a small troubleshooting section. It read: “If resistance feels zero, the magnetic unit may have shifted during transport. Solution: Turn the resistance dial to ‘8’ (max). Pedal backwards three full cranks. You will hear a soft ‘click’. Then pedal forward.” The LCD tracks real-time data such as time,

Press the key until the metric you wish to target (e.g., TIME or DISTANCE) begins flashing. Press the SET key to increase the numerical target value. Press MODE to confirm and lock in your target.

Wipe down the handlebars, console, and seat with a damp cloth to remove sweat and prevent corrosion.

Mount the console to the bracket using the small screws provided. Operating the Console and Computer Programs

: Connect the upper computer cable to the lower cable before sliding the handlebar post into the main frame. Ensure the tension control cable is securely hooked if your model uses manual tension. Feed the wires through the top and plug

Check the pedal spindles and crank arms. Lubricate any moving joints or threads outside the main shroud with a silicone-based lubricant. Do not open the sealed plastic shroud. If youg., console error code, resistance failure, noise). The age or condition of your machine. Any troubleshooting steps you have already tried.

Every few weeks, inspect and tighten all bolts, nuts, pedals, and seat knobs. Vibrations from regular use can slowly loosen components over time. Troubleshooting Guide Potential Cause Troubleshooting Step Power connection issue

If the bike feels uneven, use the adjustable leveling feet to compensate for uneven flooring. Tightening Hardware: