Before installing or replacing your unit, ensure your system matches the precise dimensions and industry compliance standards of the genuine Caraflo V200: 45mm exactly Inlet/Outlet Connections: 1/2" BSP male threads
Secure the valve from behind using the provided backplates and compression nuts. 3. Connect Supply Pipes Attach your hot and cold water feeds to the 1/2" BSP tails.
: The unit typically includes a specific drain-down key in the original box.
: Periodically check the "O-rings" and washers where the hose meets the mixer. If you notice a drip, these inexpensive parts are usually the culprit and can be replaced easily. Technical Troubleshooting Low Pressure caraflo v200 shower instructions
To increase the temperature beyond the safety stop, press the and continue turning the handle.
“Shower runs cold when toilet flushed” → Thermostat should compensate; if not, clean filters or replace cartridge.
Take out the wire mesh filters located inside the hot and cold inlets. Before installing or replacing your unit, ensure your
45mm Hole Centers |<------------->| +-------+-------+ | (H) | (C) | <-- Brass Tails (1/2" BSP Threads) +-------+-------+ Pre-Installation Checklist
Air lock in the caravan water system or failing pressure switch on the pump.
This is critical for the Caraflo V200. Wrap the shower arm threads clockwise. Do not use 5+ wraps; the V200’s swivel nut is deep but sensitive to overtension. : The unit typically includes a specific drain-down
Turn the Caraflo V200 flow control completely to the On position, and rotate the temperature dial all the way to the hottest setting. This opens internal check valves and lets pooled water escape.
If water is left inside the Caraflo V200 during freezing weather, the expanding ice can crack the internal valve body and damage pipework. The unit is designed to be easily drained, but you must follow the correct sequence.