Bonavita Hudson Ii Lifestyle Crib Instructions -

Slip a spring washer and a flat washer onto a long Allen bolt. Insert the bolt from the outside of the headboard into the side rail, threading it directly into the barrel nut.

Attach the opposite ends of the bed rails to the front footboard panel.

If utilizing a daybed configuration, you can leave the front open or install a (sold separately) to prevent your toddler from rolling out of bed at night. 2. Converting to a Full-Size Bed

Before beginning assembly, lay down a soft blanket or rug to protect both the wooden parts and your floor.

Having the right tools and space will make the assembly process much easier. bonavita hudson ii lifestyle crib instructions

(Allen wrench, JCBC bolts, spring washers, barrel nuts, and metal brackets) 2. Required Tools Included: Allen Wrench (Hex Key)

Complete Guide and Assembly Instructions for the Bonavita Hudson II Lifestyle Crib

The Ultimate Guide to Bonavita Hudson II Lifestyle Crib Instructions

: Using power screwdrivers can damage the natural wood or strip the hardware. Maintenance & Safety Checklist Slip a spring washer and a flat washer

If you are currently missing any specific parts,I can provide the exact dimensions or troubleshooting steps for that part! Share public link

Wipe the crib down with a soft cloth dampened with warm water and mild dish soap. Avoid harsh chemical cleaners or abrasive pads that could strip the non-toxic, baby-safe finish.

Ensure you have all the following components before opening hardware blister packs: (End piece) Right Side Panel (End piece) Front Gate / Rail (Lower profile panel) Back Panel / Headboard (Higher profile panel)

Insert the long JCBC bolts through the side panels into the footboard inserts. If utilizing a daybed configuration, you can leave

Locate the four metal mattress brackets and the flat metal spring framework.

Lay out all components and group them together. A standard Bonavita Hudson II crib consists of: The tallest solid panel. Footboard: The shorter front panel.

The stabilizer bar provides essential structural integrity. Insert barrel nuts into the bar’s pre-drilled holes, aligning them to capture the incoming bolts. Use 3 1/8" bolts and nylon washers to secure the bar between the two side panels. 3. Attach the Mattress Support

Hand-tighten the bolts so the frame stands independently but remains slightly flexible. Step 3: Install the Metal Mattress Support

Long bolts (approx. 3 inches) for main frame corners.