K150 Pic Programmer Software Windows 10 【Safe】

Click , then click Let me pick from a list of available drivers on my computer .

The yellow exclamation mark should instantly disappear, and Device Manager will display a clean COM port assignment (e.g., COM3 or COM4 ). Note this COM port number down.

| Error Message | Cause | Windows 10 Fix | | :--- | :--- | :--- | | “The driver is not intended for this platform” | Trying to install 32-bit driver on 64-bit Windows 10 | Use PICPGM’s WinUSB driver. Do not use the CD driver. | | “USB device descriptor failed” | CH340 chip is counterfeit or driver clash | Uninstall all USB drivers under “Universal Serial Bus devices” in Device Manager, then reinstall CH340 driver. | | “Failed to open device. Access denied.” | Another application (like Arduino IDE) has the COM port locked | Close all serial monitor software. Change COM port number in Device Manager to COM1-COM4. | | “PIC not found. MCLR voltage error.” | Incorrect Vpp voltage or poor connection | Windows 10 USB ports provide 5.0V, but some PICs need 13V. Check your K150’s jumper for external power. Ensure target PIC is powered externally (K150 supplies limited current). | | “Verify failed at address 0x0000” | Timing issue due to Windows 10’s USB polling | In PICPGM, increase the “Delay for Vpp” to 50ms. In WinPic800, reduce communication speed to “Low.” |

To successfully use the K150 on Windows 10: k150 pic programmer software windows 10

: Newer official Prolific drivers often flag these older chips as "phased out" or "unsupported," resulting in a "Code 10" error in Device Manager. : You must manually install an older, unofficial driver (often version 3.3.2.102 or similar from circa 2008). Installation Tip : Once the old driver is installed, you may need to use Device Manager

Assuming you want a short paper (overview + instructions) about using the K-150 PIC programmer software on Windows 10, here’s a concise, structured draft you can use or adapt.

: Available on , this document provides a deep dive into the firmware and software compatibility for the K150 and related DIY kits. K150 PIC Programmer Schematic and Protocol Manual Click , then click Let me pick from

Avoid unless you have a Windows XP virtual machine.

Many K150 units pretend to be a PICkit 2. Try:

Even after installation, Windows might still pick a wrong driver. You need to force the correct one. | Error Message | Cause | Windows 10

To fix this, you must bypass the automatic updates and manually force Windows 10 to use an older, compatible driver version. Step 1: Downloading the Software Bundle

Lift the lever on the Textool ZIF socket. Place your PIC chip into the socket, aligning Pin 1 with the top of the lever side according to the diagram displayed inside the Microbrn software window. Lower the lever to lock it.